How to revolve a 2D sketch into a round 3D part (knobs, bottles, wheels)
Draw half the outline of a round part against an axis, then spin it into a solid: knobs, feet, bottles, wheels, anything turned on a lathe.
In the program, this lesson runs in a practice workspace beside your own design and checks each step as you go.
What you will make
A drawer knob 30 mm across and 34 mm tall: a round base, a stem and a ball, made from one revolved sketch.
What you will learn
- Switch a sketch from Extrude to Revolve
- Read the red revolve axis
- Draw half an outline that touches the axis
- Use a circle across the axis for a ball
- Change the number of sides and the angle afterwards
Step by step
Open the sketcher
Press Sketch (K) to open the sketcher.
A revolved part starts as a flat drawing, just like an extruded one. The only difference is what is done with it.
You should see: The sketcher fills the window.
Switch to Revolve
In the bar along the bottom, change Extrude to Revolve.
Extrude pushes a drawing straight up. Revolve spins it round an axis, like clay on a potter's wheel or wood on a lathe.
You should see: A red dashed line appears, marked Revolve axis. Everything is spun round this line.
Draw the base
Pick Rect (R) and draw a rectangle to the right of the red axis, with its left edge on the axis. Set its size to 15 × 4 mm in the panel on the right.
You only draw half of the part: the half to the right of the axis. 15 mm out from the axis becomes 30 mm across when it is spun.
You should see: A flat 15 × 4 mm rectangle touching the red axis.
Tip: With Snap on, the rectangle's edge clicks onto the axis as you drag it. If the size boxes don't show, click the rectangle with Select (V) first.
Add the stem
Draw a second rectangle standing on top of the base, also with its left edge on the axis. Make it 4 × 20 mm.
Shapes that touch or overlap in a sketch join into one outline. 4 mm out from the axis gives a stem 8 mm thick.
You should see: A tall thin rectangle on the base, against the axis.
Add the ball
Pick Ellipse (E) and draw a circle (hold Shift) 12 × 12 mm, with its middle on the axis, at the top of the stem so the two overlap.
Only what is to the right of the axis is used, so a circle centred on the axis gives a half circle, and a half circle spun round is a ball.
You should see: A circle sitting across the axis at the top of the stem.
Spin it
Tick Preview in the bottom bar if you want to see the result first, then press Done (top right).
The outline is spun a full turn round the axis. The part remembers its sketch: double-click it to change the drawing, and the knob follows.
You should see: A round knob in the 3D view: a base, a stem and a ball on top.
Give it flat sides
Click the knob. In the panel, set Revolve sides to 8.
Sides is how many steps the turn is made in: 64 looks round, 8 is an octagon that is easier to grip, 6 fits a spanner. Revolve angle under 360° gives a part turn, a handy way to see a cross-section.
You should see: The knob has eight flat sides.
Round and bevel edgesIntermediate · 6 min · Round the top edges of a part and bevel its bottom edges, the two edge treatments that make prints look and feel finished.