SimpCAD XSimpCAD X BETA

Orbit, pan and zoom the 3D view in a CAD program

Beginner · about 3 minutes · part of Getting Started

Turn, slide and zoom the view, look at one part close up, and always find your way home.

In the program, this lesson runs in a practice workspace beside your own design and checks each step as you go.

What you will make

You can look at any part from any side, and never lose your design.

What you will learn

Step by step

  1. Orbit

    Hold the right mouse button and drag on an empty bit of the view: you go round the workplane.

    Seeing a part from the side or from below shows things the top view hides.

    You should see: The view has turned.

    Tip: Touch screens: drag with one finger. A trackpad: drag with two fingers.

  2. Pan

    Hold the middle mouse button (press the wheel) and drag, or hold Shift and right-drag. The view slides; the point under the mouse stays under the mouse.

    You should see: The view has slid sideways.

    Tip: Touch screens and trackpads: drag with two fingers.

  3. Zoom

    Point at the orange cylinder and scroll the mouse wheel towards you: the view zooms in on whatever is under the mouse.

    You can zoom right down to fractions of a millimetre for small details.

    You should see: You are much closer than before.

  4. Zoom to one part

    Click the blue box, then press F. The view frames just that part.

    You should see: The blue box fills the view.

    Tip: F is quickest when a part is far away or tiny. Shift+F frames the whole workplane.

  5. Go home

    Press the house button on the left of the view (or the Home key). The whole workplane comes back into view.

    Whatever happens to the view, Home brings it back. Your design is never moved by the camera.

    You should see: You see the whole workplane again.

Tools used

Camera

Next

All tutorials · Tool reference · 3D modelling for beginners