Overhang map
A switch: while it is on, faces that lean out too far to print without support turn orange (close to the limit) and red (needs support), live as you design. Faces sitting on the bed never count. The card shows how much area needs support and can turn the selected part to its best way up.
When to use it
While you design, to see what will need supports: orange is near the limit, red needs support.
How to use it
- Set the limit to what your printer manages (45° is the usual rule).
- Select a part and press Best orientation to lay it the way that needs the least support.
Limits
- Uses the overhang angle from your printer settings (45° is usual).
Get a design ready to printBeginner · 4 min · Turn parts onto their best flat faces, check for overhangs that need support, and export a 3MF.