SimpCAD XSimpCAD X BETA

Clean up a 3D scan

Intermediate · about 5 minutes · part of Modifying Models

Open a scan in Scan Studio, read its health check, clean it in one click and see how far it moved from the original.

A scan that is one closed solid, ready to print, with its history kept.

In the program, this lesson runs in a practice workspace beside your own design and checks each step as you go.

What you will make

A scan that is one closed solid, ready to print, with its history kept.

What you will learn

Step by step

  1. Open Scan Studio

    Press Scan Studio at the right of the tab row, above the tool bar.

    Scan Studio is a workspace just for scans: the design panels step aside and the scan tools take their place.

    You should see: Tabs along the top, your scan on the left, its numbers along the bottom.

  2. Read the health check

    Look at the Health panel on the right and click H1 in the holes list.

    A printer needs one closed solid. The check counts the separate pieces, the holes and the open edges, and the list takes you to each one.

    You should see: 3 pieces and 1 hole; the view moves to the hole at the top.

  3. Quick clean

    Press Quick clean (top row, Clean).

    Quick clean takes off the loose bits, fills every hole with a patch that follows the surface, and makes very big scans lighter: one Undo step.

    You should see: Health says Printable: one closed solid; the history shows pieces 3 → 1 and holes 1 → 0.

  4. How far did it move?

    Press Deviation (bottom row, Compare).

    Scan Studio keeps the original with the scan. Comparing shows how much the clean-up changed the surface, in millimetres.

    You should see: Average, largest and 95 % figures, and a bar chart of the distances.

  5. Back to design

    Press Done (bottom right).

    The cleaned scan is an ordinary part now: add holes, cut it, or send it to the printer.

    You should see: The normal workspace, with the cleaned scan.

Next

All tutorials · Tool reference · 3D modelling for beginners