Sweep
Moves a shape along a path to make a solid: a circle along a curve makes a pipe, a square along a zig-zag makes a bar with neat corners.
When to use it
For pipes, rails, handles and anything that follows a path.
How to use it
- In a sketch, draw the shape (a closed outline, like a circle) and the path (an open line or curve: Line, Pen or Spline). Press Done.
- Select the sketch and press Sweep. (The shape and the path can also be two sketches: select both.)
- Add twist or change the end size in the panel afterwards.
Options
- The shape
- A closed outline: a circle for a round pipe, a square for a bar, any outline for a moulding. Shapes with holes (a ring) make hollow tubes.
- The path
- An open line, arc or curve that the shape travels along, drawn with the Line, Pen or Spline tool.
- In one sketch
- Draw the shape and the path in the same sketch, select it and press Sweep. The shape stands up across the start of the path.
- In two sketches
- Select both (click one, Shift+click the other) and press Sweep. A shape drawn standing up keeps the way round it was drawn.
- Corners
- Corners in a line path are mitred, like a picture frame. Very sharp ones (over 120°) are rounded a little so the shape can’t fold into itself.
- Twist and end size
- In the panel afterwards: Twist turns the shape as it goes (a spring, a twisted rail); End size makes it grow or shrink along the path.
- If it looks rough
- The path bends tighter than the shape is wide, so the shape folds into itself there (you’re told where). Make the shape smaller, or draw that bend wider.
- Change it later
- Open the sketches in the Design tree and change the shape or the path: the sweep follows.
Good for: pipes and tubes, handles, rails and runners, picture-frame and trim edges, cable channels, springs (with twist) — anything that is the same shape all along a line.
Limits
- A tight bend smaller than the shape's own size folds the part over itself: make the bend wider or the shape smaller.