Loft
Blends smoothly between two or more sketches stacked at different heights, like a vase going from square to round.
When to use it
For a smooth change from one outline to another: a square base to a round top, a vase, a nozzle.
How to use it
- Draw each outline as a sketch (1 mm tall).
- Lift them apart, select them all, press Loft.
Options
- Sections
- Each closed sketch is one cross-section. Stack them at different heights with the black cone (or drop one on a workplane above the other).
- Smooth or ruled
- Smooth runs a gentle curve through all the sections; Ruled goes straight from one to the next, like a lampshade.
- Twisting
- The outlines are matched up so the loft doesn’t twist; draw the sections the same way round (all clockwise or all anticlockwise) for the cleanest result.
- Open lines
- A loft needs closed outlines. An open line can’t be lofted: close it in its sketch.
Good for: vases and bottles, a round-to-square duct or adapter, funnels, rocket and boat hulls.
Limits
- The outlines are joined in the order of their heights; very different outlines can twist. Keep the number of corners similar for a clean result.